Operation Manual

21
Programming acknowledged Successful remote programming of a calling number or calling number sequence
Programming, abort Faulty remote programming of a calling number or calling number sequence
Sensor n activated Announcement if sensor n is still in alarm mode
Supervision (I/II/III) < due to
noise / sensor n> activated
Confirmation of DTMF 5 : announcement of the activated supervision functions,
indicating the supervision modes in accordance to the position of the selection
switch (I/II/III)
Supervision (I/II/III) activated
Confirmation of DTMF 9 : Switch to active supervision mode an announce
monitoring functions at current position of the selection switch (I/II/III)
Supervision (I/II/III) deactivated
Confirmation of DTMF 7 : Switch to inactive supervision mode an announce
monitoring functions at current position of the selection switch (I/II/III)
Unacknowledged alarms: n Quantity of unacknowledged alarms
8.3 Functional checks
8.3.1 Test-call
We strongly advise to make a test-call to check functionality of EasyAlarm® before starting operation.
8.3.2 Test alarm functions
Even though the alarm unit is maintenance free (except the battery) a periodical function test should be carried out,
especially:
 Emergency button
 Wired sensors
 Acoustical monitoring
8.4 Battery check / replacement
If the announcement „Battery error“ is initiated after switching on EasyAlarm®, the battery should be replaced
immediately as follows:
1. Slide function switch to OFF
2. Disconnect EasyAlarm® from the telephone network, by removing the telephone cord
3. Open battery compartment and remove old battery
4. Insert new battery and close battery compartment
5. Reconnect telephone cord to EasyAlarm®
Notes:
 Always use fresh 9V-batteries
 Dispose the old battery properly
8.5 Maintenance
Slide function switch to OFF and remove telephone cord. Clean EasyAlarm® if necessary using a moistened cloth and dry
it afterwards.
Note:
 Do not use cleaning agents or solvent