Operation Manual

15
6.4 How to program PIN-Code
You can change remote access PIN-code as follows:
1. Slide function switch to PROG
2. Press #.
 You can prevent the alarm unit from unintended programming by pressing * .
3. Enter desired PIN-code (4 to 7 digits!)
4. Press #.
5. Re-enter PIN-code for confirmation
6. Press #.
 If PIN-code is re-entered correctly it will be announced. If you selected program locking the additional
message „programming inactive: PIN” will be announced. In case of an incorrect programming the message
announced „Error“ will not be stored => old PIN-code remains active.
7. Slide function switch to OFF
6.4.1 Lock program mode
If you initiated programming new PIN-Code with key * the program mode is locked unless you unlock by re-entering
PIN-code. This feature prevents from unintentional reprogramming during operation.
6.4.2 Unlock program mode
Having the programming blocked as described in section 6.4.1, you can unlock as follows:
1. Slide function switch to PROG
 Message „Programming inactive: PIN“ will be announced
2. Enter PIN-code and press #.
 By entering correct PIN-code you will hear a confirmation beep, otherwise message „Error“
3. Slide function switch to OFF