Operation Manual

14
6.2 Designation of the calling number sequence
6.2.1 Standard sequence
Alarm triggered Calling number 1
Alarm not acknowledged
by called party 1
Calling number 2
alarm not acknowledged
by called party 2 same for calling number 3 to 9
The alarm is acknowledged by pressing DTMF 0 ( section 7.7.5).
The alarm is passed to next party immediately by pressing DTMF 8 or after connection time-out.
6.2.2 How to program calling number sequence
1. Slide function switch to PROG
2. Enter * * 0.
 Current calling number sequence will be announced followed by “to modify press * , to stop press # “
3. To maintain the current programming, go to point 5. Otherwise enter *. .
4. Enter the desired sequence (max. 9 digits)
5. Slide function switch to OFF
Sample for programming calling number sequence:
a) ’123’ => calling number 1 will be dialled, followed by calling number 2, followed by calling number 3.
b) ’111133322’ => first calling number1 will be dialled (4 call attempts are made), followed by calling number 3 (3 call
attempts are made), followed by calling number 2 (with 2 call attempts).
Notes:
 The calling number sequence is factory set to ‘123456789’, but a general reset according to section 10.1 will NOT
RESET the calling number sequence!
 In case of an un-programmed or deleted calling number, the calling number sequence will continue with the next
number of the sequence.
 If a dialled number is busy and another call attempt is programmed, the waiting period before re-dialling is 30 sec.
 If the calling number changes within the sequence, dialling of a new number starts without delay
6.3 How to select user language / How to record individual message
An individual announcement can be recorded as follows:
1. Shift function switch to PROG
2. Enter * * #.
 Current individual message will be announced followed by “to modify press * , to stop press # “
3. Select language for user announcements: (facultative)
Press key 1 to 4 according to desired user language (i.e. 1=DE/2=FR/3=GB/4=IT)
4. Press * and start speaking
5. Press # to finish recording, max. duration is 12 seconds
 New individual message will be announced
6. Shift function switch to OFF
Note:
 Repeat step 3 and 5 until you are satisfied with individual message.
6.3.1 Remote recording of individual message during handsfree connection
1. Enter DTMF * * # #
 Current individual message will be announced followed by “to modify press * , to stop press # “
2. Select language for user announcements: (facultative)
Press DTMF 1 to DTMF 4 according to desired user language (i.e. 1=DE/2=FR/3=GB/4=IT)
3. Start recording by sending DTMF * , start talking (max. 12 s) and finish by sending DTMF # .
 New individual message will be announced
4. Wait until the message “Abort” confirms the end of the programming
Note:
 Remote recording can be enabled / disabled according to section 10.8.1.
if called party 3 does not acknowledge the alarm, the calling
number sequence is repeated the number of programmed alarm
repetitions times (default value: two alarm repetitions,
programming see section 10.2)