Use and Care Manual

IMPORTANT:
THIS STEP IS REQUIRED TO ASSURE
SAFE OPERATION FOR INTERIM
HEIGHTS
NOTE THAT THE BOTTOM LOCKING
LEVERS WITH PULL RINGS LOCK IN
THE UP POSITION.
e. If any locking levers are not at the
proper angle, lift the ladder by the tubes
and gently tap on the ground. This will
normally bring the locking levers to correct
angle.
IMPORTANT:
NEVER USE THE LADDER BEFORE
ASSURING THAT THE LOCKING
MECHANISMS ARE PROPERLY ENGAGED.
NEVER PULL RINGED LOCKING LEVERS
WHEN LADDER IS IN USE.
c. (Important) If the chosen height is in
fact not the height desired and need to
adjust height either higher or lower, you
must reset the ladder by lowering the
ladder back down into starting position by
pulling the release rings located on
first/bottom rung. Figure 7
Allow ladder to completely descend with
each rung stack onto one another.
Figure 10
d. Now select your new desired height and
grasp outside edge of newly chosen rung
(height) Figure 11 and pull up to fully
extend all rungs below. Figure 12
Make sure that all red locking levers are in
their locking positions and bottom rung
pull rings are in their locking positions.
Figure 12
UNLOCKED
POSITION
DOWN
LOCKED
POSITION
UP
Figure 12
Figure 10
Red Locking
Levers:
Locked
position
for all red
levers
except
bottom
pull rings.
Always ensure
that the red
locking
mechanism
have fully
engaged
by checking
that the red
locking levers
have dropped
to an angle of
approximately
60 degress
Figure 11
BOTTOM PULL RINGS