Use and Care Manual

OPENING YOUR LADDER
FULL EXTENSION
1. The EasyAccess Innovations Telescopic
Ladder is very portable and should be
carried as shown in Figure 1
2. To begin the opening process, place the
ladder on a firm level surface and stabilize
with your foot as shown in Figure 2
IMPORTANT:
DO NOT OPEN LADDER FROM THE TOP
UNLESS OPENING TO THE FULL HEIGHT.
SECTIONS MAY NOT PROPERLY LOCK
AND YOU COULD BE INJURED
3. There are two (2) ways to OPEN your
ladder. Full extension or extension to any
interim height.
IMPORTANT:
NEVER USE THE LADDER BEFORE
ASSURING THAT THE LOCKING
MECHANISMS ARE PROPERLY ENGAGED.
NEVER PULL BOTTOM LOCKING RINGS
OR PUSH UP ON ANY RED LOCKING
LEVERS WHEN LADDER IS IN USE.
1. To open ladder to full height, use the
following procedure:
a. To begin the opening process, place the
ladder on a firm level surface and stabilize
with your foot. Figure 2
b. Starting with the top rung, Figure 3,
open each section to its full extension (one
section at a time) until all sections are fully
open. Figure 4 & Figure 5
c. Check to be sure the red locking levers
are at an angle of approximately 60
degrees, indicating that the locking
mechanisms are properly engaged.
Figure 6
NOTE: THE BOTTOM PULL RINGS LOCK IN
THE UP POSITION.
Figure 1 Figure 2
Figure 3
Figure 5
Figure 6
Red Locking
Levers:
Locked
position
for all red
levers
except
bottom
pull rings.
Always ensure
that the red
locking
mechanism
have fully
engaged
by checking
that the red
locking levers
have dropped
to an angle of
approximately
60 degress
UNLOCKED
POSITION
DOWN
LOCKED
POSITION
UP
BOTTOM PULL
RINGS
Figure 4