Use and Care Manual

ManualsBrandsEasyAccess Innovations ManualsBuilding materials10.5 ft. Aluminum Telescopic Ladder with 300 lb. Load Capacity Type 1A Duty Rating

Use and Care Instructions for the

EasyAccess Telescopic Ladder

READ ALL INSTRUCTIONS CAREFULLY BEFORE

ATTEMPTING TO USE THE LADDER

DO NOT OPEN THE LADDER FROM THE TOP UNLESS

EXTENDING TO FULL HEIGHT. IT MAY COLLAPSE!

With proper use and care, your EasyAccess Innovations

Telescopic Ladder will provide you with a safe and reliable

service. Please read and follow these instructions carefully.

Save this booklet for future reference.

info@easyaccessinnovations.com

www.easyaccessinnovations.com

IMPORTANT

WARNING!

FOR VISUAL INSTRUCTIONS,

PLEASE GO TO OUR YOUTUBE VIDEO

ATTENTION!

Summary of content (8 pages)

PAGE 1
Use and Care Instructions for the EasyAccess Telescopic Ladder IMPORTANT READ ALL INSTRUCTIONS CAREFULLY BEFORE ATTEMPTING TO USE THE LADDER WARNING! DO NOT OPEN THE LADDER FROM THE TOP UNLESS EXTENDING TO FULL HEIGHT. IT MAY COLLAPSE! ATTENTION! FOR VISUAL INSTRUCTIONS, PLEASE GO TO OUR YOUTUBE VIDEO With proper use and care, your EasyAccess Innovations Telescopic Ladder will provide you with a safe and reliable service. Please read and follow these instructions carefully.
PAGE 2
OPENING YOUR LADDER 1. The EasyAccess Innovations Telescopic Ladder is very portable and should be carried as shown in Figure 1 2. To begin the opening process, place the ladder on a firm level surface and stabilize with your foot as shown in Figure 2 IMPORTANT: Figure 1 Figure 2 DO NOT OPEN LADDER FROM THE TOP UNLESS OPENING TO THE FULL HEIGHT. SECTIONS MAY NOT PROPERLY LOCK AND YOU COULD BE INJURED 3. There are two (2) ways to OPEN your ladder. Full extension or extension to any interim height.
PAGE 3
CLOSING THE LADDER Care should be taken when closing the ladder. Unlocking and closing is quite simple when done carefully. Pulling down rings one at a time to unlock ladder IMPORTANT: DO NOT LOWER THE LADDER TO INTERIM HEIGHTS. ALWAYS CLOSE LADDER COMPLETELY AND THEN RE-OPEN TO DESIRED HEIGHT. To close the ladder, refer to Figure 7 and proceed as follows: 1. Hold the ladder upright and firmly grasp one of the open vertical tubes with one hand.
PAGE 4
c. (Important) If the chosen height is in fact not the height desired and need to adjust height either higher or lower, you must reset the ladder by lowering the ladder back down into starting position by pulling the release rings located on first/bottom rung. Figure 7 Allow ladder to completely descend with each rung stack onto one another. Figure 10 d. Now select your new desired height and grasp outside edge of newly chosen rung (height) Figure 11 and pull up to fully extend all rungs below.
PAGE 5
SAFETY PROCEDURES DO NOT DO Check to ensure all locking mechanisms are properly engaged before climbing the ladder gain extra height. Always have a firm level base DO Always open and close the ladder in a slow and careful manner DO Treat the ladder with care. It is a precision built product.
PAGE 6
WARRANTY Your EasyAccess ladder is covered by a 12-month warranty. The Company undertakes to replace or repair, free of charge, any defect that the Company considers to be due to faulty workmanship or material within 12 months of the sale date, except for: • Defects arising from neglect, misuse or unauthorized modifications. • Damage caused by abuse, misuse, dropping or other similar damage caused by or as a result of failure to follow transportation, storage, loading or operation, instructions.
PAGE 7
EasyAccess Innovations GUARANTEE CARD EasyAccess Innovations Telescopic Ladder LADDER NUMBER: PURCHASER NAME: ADDRESS: TOWN: ZIP CODE: DATE OF PURCHASE: THE USE OF THE TELESCOPIC LADDER AS WELL AS ALL SAFETY INSTRUCTIONS HAVE BEEN FULLY EXPLAINED TO ME.
PAGE 8
Place Stamp Here EASYACCESS INNOVATIONS 4850 Murrieta St, Chino, CA 91710 USA EasyAccess Innovations GUARANTEE CARD Your EasyAccess Innovations Telescopic Ladder is a quality product. Manufactured with great precision using carefully selected materials. We guarantee this branded product for a period of 12 months in the event of any defects which may be traced back to a fault in material or manufacturing.