Programming instructions

12
POOL/SPA MODES
The control is equipped with two independent thermostats, one for
pool temperature and one for spa temperature. This is to allow user
to preset a temperature of their choice and switch between the two
settings with the “MODE” button located on the control. When water
is flowing through the unit and the water temperature meets the
specified set point condition, the control will initiate a heat cycle.
If you do not have a spa, you can use the spa thermostat as a
second temperature setting if you do not want to maintain full
temperature all the time. For instance, if you swim on the weekends
only, you can set the temperature back during the week to save costs
but maintain a warmer temperature for a shorter recovery time for
the weekend.
The display on the control will show the thermostat being used and
the operating mode on the top line and the current water
temperature on the bottom line. The Standard mode displays are:
“POOL – HEAT”, “SPA – HEAT”,”POWER OFF”. “POOL-COOL”, “POOL-
HEAT/COOL”, “POOL SOLAR HEAT” will also be available depending
on the model. Addition programming and wiring may be required for
these features to be activated.
CHANGING SET POINT TEMPERATURE
To change the set point temperature, press either the “Up” or
“Down” arrow buttons on the control. The display will then show
“POOL or SPA TEMPERATURE SET POINT” on the top line and the
current set point temperature in numbers on the bottom line. After
adjusting to the desired temperature setting, the display will revert to
“POOL or SPA – HEAT” on the top line and the pool temperature in
numbers with “DEGREES” on the bottom line after 5 seconds of
inactivity and the new set point will be stored in memory. The default
factory setting for Pool temperature is 85 ˚ Fahrenheit (F).
ATTENTION:
There is a 180 Second time delay upon initiation of a heating cycle.
This is to ensure that the critical components do not fail due to short
cycling of the heater. A count down will be provided on the display.