Programming instructions

11
Heat Pump Features Continued
EASY ACCESS
The heater was designed for quick and easy access for installation
and diagnosis. The service panel is removed with two screws and
access to all service connections is right up front and easy to reach.
This allows the installation and service to be done quickly and
efficiently – so valuable time is not wasted.
EVEN-HEAT (Additional wiring required)
This feature allows the heater to periodically turn pool circulation
pump on and test water temp, if temp is below the set point
programmed on board, the heater will run the pool pump until it
reaches set point, then it will shut the unit and the circulation pump
back off. This feature can be set to run in one-hour increments.
SOLAR CONTROL (Additional wiring required)
The board can be set to run and monitor your pool solar systems.
There is no need to have a second and separate control system.
MOTORIZED VALVE CONTROL (Additional wiring required)
The Board now has terminals for your motorized valves; this will
allow your heater to switch the valve from pool to spa by just
pressing the “MODE” button.
HEAT PUMP OPERATION
POWER OFF
In order to shut Heat pump off, press the “MODE” button until it
reads, “POWER OFF” , while in “POWER OFF” the unit will not run. To
get out of “POWER OFF” , press the “MODE” button, that will lead you
to the “POOL - HEAT” screen where you can continue normal
operation.
CAUTION:
When the control is in the “OFF” mode, there is still high voltage to
the unit. If you want to turn the unit off for long periods of time,
shut the main power off to the unit at the main or service
disconnect.