Product Manual
** Hot Water Pressure Washers Only
OPERATING
I
NS
T
R
U
C
T
I
O
NS
1. Perform pre-start
maintenance
inspection on all applicable sys
t
e
m
s prior to operating
the machine. This is essential for the safe, effec
t
i
ve and efficient operation. You will get
optimum performance
from
yo
u
r
system ONLY if these instructions and inspections are
followed. A
n
y indication that the pressure washing system was not operated and
maintained
according
to these instructions may cancel
t
h
e
manufacturers’ w
a
rr
an
t
y.
Location – Gasoline
powered
machines must be outdoors in a well ventilated area.
Controls – Make sure all
controls
turned to the off position.
P u m p – O i l l e v e l - Level the pressure washer. Be sure oil level in the pump is
correct on dip stick. If the level is low, add the correct oil to the
proper level. USE ONLY
SAE 30 W NON-DETERGENT OIL OR HYDRAULIC 68. DO NOT OVER
F
I
LL
.
Gas Engine - Gasoline level – The engine is a 4 cycle and
u
ses
regular
octane, unleaded
fuel. DO NOT USE MIXED
F
U
EL
. Refer to the engine operation manual included with
your
pressure-washing
un
i
t
.
Gas Engine - Oil level – The engine is a 4 cycle and uses 10W30 detergent oil. Refer to
G
l
oss
a
r
y or engine
m
anua
l
.
**Oil Fired Burner - Oil Tank Level – #2 Furnace oil is
recommended f
u
e
l
for
Oil Fired
Hot Water Pressure
Washers.
It burns cleaner
and
the burner requires
less
maintenance.
Diesel fuel may be used
a
s an alternative. Do not ove
r
f
ill
burner
t
ank
.
Visually inspect all e
l
ec
t
r
i
c
a
l
components to assure they are
i
n
good condition, showing
no signs of ex
p
os
u
r
e,
breakage o
r
s
p
li
c
i
n
g.
Visually inspect all hoses, nozzles and guns to assure they are
i
n
good condition. If
replacements
are
n
ecess
a
r
y they must be
r
a
t
e
d
to withstand the machines operating
pressure and
t
e
m
p
e
r
a
t
u
r
es.
2. Attach the
high-pressure
hose to the outlet coupling on the coil heat exchange system.
Ensure that the quick disconnect connections are tightly
l
oc
k
e
d
t
oge
t
h
e
r
. Apply a sharp
pull on the hose to confirm.
Attach the wand nozzle specific to the task requirements (i.e. chemical or pressure wash).
[Quick Coupling Operation – Pull back sleeve end and insert male end into fitting, release
sleeve and confirm connection.]