Product Manual

WI
NT
ER PUMP/COIL
PROTECT I O N
The following procedure MUST be used when the pressure washing
unit is stored at temperatures below freezing.
1. All water must be
drained or blown (via co m p r esse d air) from sys t e m .
Connect a short piece of male fitted ½” garden type hose on to t h e
female inlet on the pu m p .
2. Place the open end of the hose into a wide mouthed container of f u ll
strength, winter rated, vehicle windshield washing fluid or Anti-Freeze,
RATED FOR MINIMUM -40° C .
3. Connect the pressure wand
a sse m b l y.
4. Start the engine and engage the trigger on the pressure gun. O p e r a t e
the system until the fluid runs the same co l o r as the windshield w a s h i n g
fluid. Your machine is now prepared for s t o r a ge.
5. Blow out, disconnect fluid supply & pump out excess or cap end