Operation Manual

AFTER SALES SUPPORT
www.aquarius-service.com
GB
IRE
00800 36463600
Cleaning and care
GBIRE
27
Weekly cleaning
It is recommended that you perform a more thorough
cleaning once a week, both for dry and wet shaving.
To do so, proceed as follows:
1. Use the electronic On/Off switch
5
to switch the
shaver off (see fig. A).
2. Pull the 5V plug
14
out of the shaver
(see fig.A and B).
3. Hold the shaver over the sink.
4. Push the small release buttons
4
to release the
shaving foil unit
2
.
5. Pull the
shaving foil unit up and off
(see fig.A and K).
6. Knock the
shaving foil unit out gently over a sink to
remove stubble.
7. Place the shaving foil unit on a suitable base.
8. Depress the large release button
8
to open the
shaver head
9
(see fig. A and E).
9. With the shaver head open, use the electronic On/
Off switch to switch the shaver on for approx. 5 – 10
seconds to discharge any stubble from the shaver
blades
3
.
10. Briefly press the electronic On/Off switch twice to
switch the shaver off again (see fig. A).
11. Use the cleaning brush
10
to completely remove
all stubble from the shaver blades and the entire top
part of the shaver (see fig.A and I).