Submittal Sheet

7.62m
MSG-1
SENSOR
CONNECTION
GC-1 BASE
INSTALL IN EXTERIOR LOCATION
CONT
..... .....
GC-1 CONTROLLER WITH SINGLE/DUAL PHASE
LOAD LESS THAN OR EQUAL TO 24A
CONT
..... .....
GC-1 CONTROLLER WITH LOAD
HIGHER THAN 24A OR 3 - PHASE LOADS
MSG-1 HOUSING INSTALLATION
Installation
Wiring
2 GC-1 Roof & Gutter De-Icing Controller
MSG-1 CONNECTION
MSG-1 SENSOR
WIRE INSTALLATION
At the beginning of the heating season and monthly during
operation inspect for and remove all leaves and combustible
debris from roofs gutters and downspouts. At the beginning of
the heating season the MSG-1 must be inspected for physical
damage and the snow sensor surface cleaned. To clean the
snow sensor surface:
1. Lock-out the power supply to the GC-1.
2. Remove the MSG-1 sensor housing from the gutter.
3. With a clean wet swab clean up the surface of the snow
sensor.
4. Replace the MSG-1 sensor housing in the gutter.
5. Reconnect GC-1 to the power supply.
www.easyheat.com
US T. [phone] / F. [phone]
CAN T. [phone] / F. [phone]
MSG-1
HEATING
CABLE
MSG-1
SENSOR WIRE