User`s manual

ETZ Series H.264

ETZ _v5.5.0.0 r050810

I. Static IP Address Setup

Perform the following steps to configure the DVR:

In the Internet Protocol TCP/IP Properties dialog screen,

you need to setup the following:

 IP address

 Subnet

 DNS

The specific information for the above settings are provided by

by your Internet Service Provider.

Perform the following to configure your DVR software:

First, click on the setup button on the DVR software and under the system tab,

go to Network Section.

Make sure that server type is set to TCP/IP

HTTP Port No. = 80

Port No. = 9091

Appendix ll: ETZ Network Setup

If your DVR is behind a router/firewall, the following two ports must be opened:

Port: 9091 (For client software connection)

Port: 80 (For Web-based software connection)

Make sure your DVR is setup to use these ports.