User's Manual

Installation Guide
Step1. Inserting Batteries
1. Remove the battery cover by holding the mouse with the scrolling wheel towards you, and using
your thumb to push out the batter cover along the direction indicated by the bold arrow.
2. Inset two AAA alkaline batteries. (Please refer to the diagram above for the polarity of batteries).
3. Carefully slide the battery cover back in the direction opposite to that stated in procedure .
4. Please see the bottom of this mouse, the Switch must be put on the “ON” position.
and the light of the mouse bottom will be light
5. Finish the battery setup.
Step2. Connecting the Mouse to the Dongle, and drive:
If you setup the Bluetooth (Dongle) drive or connecting Dongle, please turn out this step.
Before you install the Bluetooth Mouse, please make sure that the Bluetooth Dongle has been installed.
Software available like Wincomm, IVT or the Microsoft built-in software (can not connect to the
headset).
Any plan connecting (Dongle) will be okay, e. g. BROADCOM，CSR, It will be finished setup when
connect the USB port.
Connecting the mouse to the (Dongle) drive, please refer to (Dongle) user manual