User's Manual

reconnect it.
.
Attention Please
1. Please don’t make the mouse far away from the receiver in order to work more smoothly.
2. This mouse with save power sleeping functions, please press any key or scroll the wheel to
wake up the mouse when it is sleeping.
3. If you want to take off the mouse power, please turn off the power switch. If you will trip or not
use the mouse for a long time, please take out the batteries.
4. When the batteries lift will be expire, the red indicator lamp will be flicker. It notes that the
batteries have exhausted. So please change the new batteries.
5. The mouse have memory ID code function automatically. So the ID code will not loss, when the
power is off..
6. You can stowaway the receiver when don’t use the mouse.
Caution
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must accept
any interference received, including interference that may cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
Note
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
--Consult the dealer or an experienced radio/TV technician for help.
*The equipment is to be supplied from an identified USB port complying with the
requirements of Limited Power Source.
FCC Logo