User's Manual

line to charge, connect one side of USB line to the connector of the board, and the other side to USB connector before the mouse, thus it can successfully
charge the battery. It can charge while you use the mouse. It is full within about 8-10 hours, and then unplug the connector to stop the charge. Please note
that the time of charge may vary when the degree of discharge is different..
Attention
1, Please don’t move the mouse too far away from the receiver in order to work more smoothly..
2, You’d better use the mouse on the white desk, in this way the battery can be used longer time or if you travel outside。
3, This mouse has a power saving sleep mode .Press any key or scroll the wheel to wake up the mouse from its sleep mode。
4, If you want to turn off the mouse power, press the ID switch of the mouse for 3 seconds. To turn the power back on, please the ID switch once
again.
5, The optical mouse may not work on smooth surface, glass, any reflecting surface or 3D mouse pad.
6, If fresh batteries are changed within 10 seconds, no need to repeat the ID setup. otherwise, need to repeat ID setup.
7, You can place the receiver in the mouse when you want to carry the mouse on business, and press the switch of ID for a long time
so as to switch off the power。
Caution
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:(1)This device may not cause harmful
interference, and(2)This device must accept any interference received, including interference that may cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the
equipment.
Note
This equipment has been tested and found to comply with the limits for a class B digital device, compliant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interferent by one or more
of the following measures:
1, Adjust the orientation of the receiving antenna.
2, Increase the distance between the equipment and receiver.
3, Connect the equipment into an outlet on a circuit difference from the one to which the receiver is connected.
4, Consult the dealer or an experienced radio/TV technician for help.