User's Manual

2. You’d better use the mouse on the white desk, By this way the batteries can be worked longer time. Please remove the batteries if the mouse
will not be used for a long time.
3. This mouse with save power sleeping functions, please press any key or scroll the wheel to wake up the mouse when it is sleeping.
4. If you want to take off the mouse power, please continue to press the ID switch of the mouse bottom over 3 seconds. If you want to take
on the power, please click the ID switch once again.
5. The optical mouse will not work freely on a smooth desk ,glass, any reflecting surface, 3D mouse pad.
6. when you are moving the mouse, if the low-power indication light flickers, it shows that the batteries are using up, please change another
two new right batteries.
7. if you put the receiver into transmitter, power are cut down automatically, and you can take them away.
Caution
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the
equipment.
Note
FCC Statement:: 1.This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:(1)This
device may not cause harmful interference, and(2)This device must accept any interference received, including interference that may
cause undesired operation. 2.Changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
* Consult the dealer or an experienced radio/TV technician for help.