User's Manual

ID Setup

1. Please move the mouse near to the receiver

2. Press the ID button of the receiver by your hand, the receiver light begin to flash

3. Press the ID button of the mouse bottom with some hard and acuate object within 10 seconds,

the receiver light will flash very fast, a few seconds later it will be on which shows it is

successfully to finish the digital transmission between the mouse and the receiver. You may

start to use it.

4. Working distance: within 1-2 meters.

先按接收器

上之按钮

再按发射器底部之按钮

Important Attention Please

！！！Only confirmed the wireless mouse no memory connect it must make following

steps:

1. Please don’t make the mouse far away from the receiver in order to work more smoothly.

2. You’d better use the mouse on the white desk, in this way the batteries can be used longer time.

Please remove the batteries if the mouse will not be used for a long time.

3. This mouse with save power sleeping functions, please press any key or scroll the wheel to

wake up the mouse when it is sleeping.

4. If you want to take off the mouse power, please continue to press the ID switch of the mouse

bottom over 3 seconds. If you want to take on the power, please click the ID switch once again.

5. The optical mouse will not work freely on a smooth desk ,glass, any reflecting surface, 3D

mouse pad.

6. The mouse have function for the ID connected forgetting automatical. No need to check the

digital connection when change the batteries, if more than that please according to the above

way to re-operate.

Caution

1.This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions:(1)This device may not cause harmful interference,

and(2)This device must accept any interference received, including interference

that may cause undesired operation.

2.Changes or modifications not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment.

Note

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. However, there is no

Then press the button of the mouse

First press the button of the receiver