User Manual

DS-2509 ( MA89P1+PAN3205)

2.4G Wireless Optical Mouse user manual

Product feature

2.4G wireless connection, operating range 10 meters

PAN3205 sensor, low power and high performance

3 switchable CPI 800/1200/1600

IR light tracing technology, work with many of surface

Energy saving design with low power indicator and power switch on mouse body

Plug & play Nano receiving adapter

Before use:

1. Find the wireless mouse and Nano receiver in package

2. Plug Nano receiver to USB port on PC

3. Switch the button at the bottom of mouse body, battery cover can be open (check

the pictures), Install 1PCS AA battery into Mouse body Properly

Put on power switch at the bottom of Mouse, LED indicator will keep flash for few

second, the Mouse is ready to work.

Product specification

1. CPI adjustable function

With 3 adjustable CPI 800/1200/1600, factory setting is 1200CPI. Press the switch

button at bottom of Mouse can easy to adjust CPI(check picture for the button).

LED indicator( will flash one time while it converting to 800CPI, LED will flash

twice while it converting to 1200CPI, LED will flash three times while it

converting to 1600CPI.

2. Saving power mode and power switch off

If mouse is stay out of work for 8 minutes, it will turn to power saving mode,

press any button to restart it.

If you turn off PC or take out Nano receiver from USB port, press any button or

move the mouse to enter the power saving mode.

3, Nano receiver

A very small size design for Nano receiver, it can be plug and stay on USB port

of PC/Notebook without interference.

Portable design for travel, Nano receiver can be plug into the slot next to the

battery position.

4. Customized function for the fourth and fifth button

There is two side key of mouse, it is default for toward/ backward function. End

user can set up the function by software, it has more than 20 function for option.

The software can be download from website (check the local distributor) .

PAGE 1
DS-2509 ( MA89P1+PAN3205) 2.4G Wireless Optical Mouse user manual Product feature 2.4G wireless connection, operating range 10 meters PAN3205 sensor, low power and high performance 3 switchable CPI 800/1200/1600 IR light tracing technology, work with many of surface Energy saving design with low power indicator and power switch on mouse body Plug & play Nano receiving adapter Before use: 1. Find the wireless mouse and Nano receiver in package 2. Plug Nano receiver to USB port on PC 3.
PAGE 2
Reconnection Both of mouse and Nano receiver has a built-in code, It can be setting one mouse to one receiver, or few of mouse to one receiver. Mouse and receiver need to reconnect under the condition of High temperature, high magnetic, strong vibrate. 1. Plug off the Nano receiver from USB port, and plug it on 2. Move RF mouse within 50CM to Nano receiver, re-install the battery, Press any key to reconnect, the above operation must be completed in 15 seconds. 3. Mouse will ready to work after reconnection.