User's Manual

4: Built in Nano receiver:
No influence for Nano receiver to be inserted into the USB port for a long
time. It is convenient to put the Nano receiver inside the mouse.
Reconnection
There is one identification code of the mouse. High temperature, high
magnetic field and vibration will influence the code and need to be
reconnected
1: Unpin the receiver and reinsert
2: Press The scroll wheel and the right button simultaneously for a few
seconds and then loose
3: Recoonection successful ,the device can be used again.
Attention:
1:This mouse adopts infrared for shift detection subject to the relevant
safety regulations.
2:2.4G wireless radio wave for transmission and up to 10 meters.The
working distance will be shorten by barrier
3: The Uneven or reflective desktop will influence proper use
Caution:
Any alteration or amendment of this device is prohibited for user without
any explicit permission from responsible authorities.
FCC STATEMENT
1. This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
2. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following