User's Manual
Attention Please
1, Please don’t make the mouse far away from the receiver in order to
work more smoothly.
2, You’d better use the mouse on the white desk, in this way the
batteries can be used longer time. Please remove the batteries if
the mouse will not be used for a long time.
3, This mouse with save power sleeping functions, please press any
key or scroll the wheel to wake up the mouse when it is sleeping.
4, you want to take off the mouse power, please continue to press
the ID switch of the mouse bottom over 3 seconds. If you want to
take on the power, please click the ID switch once again.
5The optical mouse will not work freely on a smooth desk ,glass, any
reflecting surface, 3D mouse pad.
6No need to check the digital connection within 10 seconds when
change the batteries, if more than that please according to the above
way to re-operate.
Caution
Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate
the equipment.
Note
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interfer-
ence to radio com- munications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.