User's Manual

Wake-up Feeler: two ways.
1. touch mode: Grasp the mouse
2. press mode: Click any key
Features of receiver:
Frequency: 27MHz
Interface: PS/2, USB & Combo available
Current: +5V DC
Assembly Instructions:
1. Connect the receiver:
Connect the receiver with interface of computer: please note that PS/2 Interface must be connected
before turning on the computer, USB connector can be used whenever it is plugged.
2. Battery Installation
Open the battery cover on the bottom of the mouse, insert two brand new batteries, (please note that
“+”and “-” should be putting at the right side or it will cause short circuit)(As per Picture)
WARNING:
Different kinds of batteries (e.g. Alkaline and Rechargeable batteries) mixed using may cause
explosive damage.
3. Adjusting code
Before using it, please be sure that the adjusting code are not interfered, for example, when several
mice are used at a close distances, the ID codes can be set through the buttons on the bottom of the mouse,
Thus, it start working within 4 seconds either of them can be pressed first (As per Picture).
4. Usage
The receiver (box) can be placed any distance within 1.5M to 2M. Mouse can be used on any desktop
surface. (We recommend to use it on any white or lighter color surface of desktop, thus, the power can be
saved.)
Simple maintenance and technique support
If you are not going to use it for a long time, please take the batteries out to avoid any damages on the
circuit or if replacement time for batteries is too long, the adjusting code needs to be reset. In case it cannot
be used, do not open up the mouse yourself. You should contact the service center that near by your place.