Specifications

EASTAR UHP-1000 SERIES SATELLITE ROUTER

INSTALLATION AND OPERATION MANUAL, V. 2.3

(SW VERSION 2.2.9)

Packets, Bytes - Number of packets and bytes which have used the given record (values are reset to zeros

after any changes in the route Table)

A 10.0.0.12 /24 Ethernet - 105 5460

IP-address on LAN-interface. There was traffic on it.

command - ip ad 10.0.0.12 /24

R 10.0.1.0 /24 10.0.0.10 - 0 0

Static route. Bytes counter does not work with such records, only packets are counted.

command - ip ro 10.0.1.0 /24 10.0.0.10

A 30 192.168.0.1 /24 Ethernet - 0 0

One more IP-address but it belongs to route Table with VLAN=30.

command - ip ad 192.168.0.1 /24 30

M 30 192.168.1.0 /24 Mod/LOW ->200 0 0 0

Incoming packets with VLAN=30 on the relevant network will be transmitted via modulator with SVLAN=200, with

low priority via channel 0 Traffic Shaper.

command - ip ma 192.168.1.0 /24 ml 200 0 30

M 30.0.0.0 /23 Mod/HIGH->0 0 0 0

command - ip ma 30.0.0.0 /23 mh 0

V Demod. RX->0 IP Router - 0 0

Receive SVLAN 0 with SCPC demodulator.

command - sv re sc 0

V 30 TDMA RX->200 IP Router - 0 0

Receive SVLAN 200 with TDMA demodulator into route Table VLAN 30

command - sv re td 200 30

Unroutable: 0 Last: 0.0.0.0 -> 0.0.0.0 Screened: 0

Number of packets that failed to be routed, as well as IP-addresses of the source and destination of the last of

such packets. .

Screened – Counter of packets that tried to get directly to the modulator from demodulator and have been

dropped.

DSCP: 0:H.H..... 8:..H..... 16:H....H.. 24:........

DSCP values map that have to be treated as high priority ones. In this case IP-packets with DSCP field equal to

0, 2, 11, 16 and 21 will be transmitted with high priority (with map records with md priority).

UDP/RTP ports: 1000-1100

List of ranges of UDP ports for compression of RTP headers.

To clear statistics you may use ―clear counters ip‖ command.

2.8.4 VLAN support

UHP-1000 routers support most of the IEEE 802.1q standard capabilities. Support for

multiple route Tables associated with VLAN values on the Ethernet interfaces is provided.

UHP-1000 router can receive traffic over LAN with VLAN tag 1-1020 and transmit it to the

satellite with the assigned SVLAN value. Reception for satellite and traffic routing to LAN

with tagging added is also possible. VLAN 0 is untagged.

Within UHP-1000 router, reception of traffic over one VLAN and immediate resending it back

to LAN over another VLAN without transmitting it via a satellite is impossible.

To summarize, the user can do the following:

 Decide which VLAN to use to receive traffic from LAN (or receive untagged to the