Specifications

ManualsBrandsEastar ManualsComputer equipmentUHP-1000 SERIES

EASTAR UHP-1000 SERIES SATELLITE ROUTER

INSTALLATION AND OPERATION MANUAL, V. 2.3

(SW VERSION 2.2.9)

2.2.9 Command interface and command syntax

When opening a command session (Telnet of USB) the router can, depending on the

configuration, request a password. If password is not set the commands can be entered

immediately.

The system invitation starts with the router name (it is set using the relative command).

Then enter «#» symbol in the administrator mode or «>» symbol in the user mode (user

cannot change configuration).

Router commands include key words and parameters. All key words can be reduced to

two letters. Letter case is unimportant. Wrong entered symbols can be edited by returning

to them using Backspace key. ―Left‖ and ―right" arrows cannot be used for editing. ―Up‖

arrow is used to recall commands used earlier.

Commands list can be printed using ―help‖.

UHP# he

---------- Interface control

interface ethernet|serial|demod|modulator disable|enable - IF Control

clear interface ethernet|serial|demod|mod - Reinitialize interface

---------- Ethernet interface parameters

ethernet mode ehalf|efull|fhalf|ffull|auto - Speed and duplex selection

arp timeout 30-3600 - ARP table purge interval

---------- Demodulator common parameters

demodulator lnb frequency 0-14000000 - LNB LO frequency (KHz)

demodulator lnb power off|on - LNB power control

demodulator search 0-200000 - Carrier search bandwidth (+/-KHz)

demodulator reference off|on - TDMA RX connector 10 MHz output

---------- Demodulator profile parameters

demodulator profile a|b disable|enable - Enable/disable profile

demodulator polarization a|b vertical|horizontal - Polarization

demodulator frequency a|b 950000-21500000 - Central frequency (KHz)

Command syntax meaning:

[ ] - optional parameter

x|y - selection of one of the key words, e.g. ―on‖ or ―off‖

x-y - numerical value in the range from x to y inclusive

STRING - symbols string

IP_ADDR - IP address, e.g. 192.168.0.1

IP_MASK - IP mask in classical or CIDR form (255.255.255.0 /24 /32)

ADDRESS AND MASK MUST BE SEPARATED BY BLANK SPACE – THESE ARE DIFFERENT

PARAMETERS.

ML, MM, MH, MD - abbreviations for the name of the modulator transmission priority

queues (Low, Medium, High, DSCP)

2.3 Interface management

Router interfaces feature the following designations in the commands set:

Ethernet - Ethernet LAN (LAN)

Demodulator - High speed demodulator (SCPC Rx)

TDMA - Packet demodulator (TDMA Rx)

Modulator - Modulator (Tx OUT)