Specifications

ManualsBrandsEastar ManualsComputer equipmentUHP-1000 SERIES

EASTAR UHP-1000 SERIES SATELLITE ROUTER

INSTALLATION AND OPERATION MANUAL, V. 2.3

(SW VERSION 2.2.9)

2.2.3 Connecting to external devices

All wire connections must be performed before powering up the router. IF cable connectors

should be screwed to the router without use of any mechanical instruments. Please, avoid

excessive force when connecting IF cables.

WARNING! Do not connect or disconnect any connecting cables to the

router with the power on. This can lead to a failure of the router and

connected devices.

Figure 11 Example of router’s connection in SCPC or TDM/TDMA terminal modes

Typically, the router UHP-1000 is connected to individual RF frequency equipment (ODU). In

such configuration IF output of the modulator is connected to the power amplifier BUC, and the

input of high-speed demodulator to LNB (Figure 11). The router will supply the BUC with 24V

power and 10MHz reference signal. Also, the router may provide LNB with 18V DC power. The

user’s equipment should be connected to the router via Ethernet switch or hub, if you plan to

connect only one device, it can be connected directly with Ethernet cross-over cable.

Figure 12 Example of router's connection in TDM/TDMA Half Mesh mode

In the Half Mesh mode the inputs of high-speed and burst demodulators should be

connected to LNB via IF splitter (Figure 12). Such splitter has to ensure by-pass of DC for

powering of the LNB and 10 MHz reference signal (required for PLL LNB normally used with

Half Mesh terminals).

2.2.4 Powering on

In a few seconds after powering the router it is ready for use. Readiness of the router will

be confirmed by "STATUS" LED indicator (blinking with a period of 1 second), as well as by

single flashes of "ERROR" indicator, meaning a lack of reception of the receiving carrier.

With factory setting the router is configured as TDM/TDMA terminal. The router requires

change of mode of operation (if necessary) and/or configuration of respective network

parameters before login into satellite networks.

UHP-1000

TDMA Rx

MCPC Rx

LAN

ETHERNET SWITCH

IF splitter

BUC

LNB

(24V, 10MHz)

(18V, 10MHz)

User’s equipment

LNB