Specifications

EASTAR UHP-1000 SERIES SATELLITE ROUTER
INSTALLATION AND OPERATION MANUAL, V. 2.3
(SW VERSION 2.2.9)
© ROMANTIS 2010 15 www.romantis.com
Figure 8 UHP-1000 series modem – rear view
1.2.2 Power connector (DC IN)
UHP-1000 router is powered with 24 VDC. AC Power supply adaptor is supplied with the set.
The router can be powered from a DC power source (batteries, DC-DC converter), but the
specific power supply mode should be agreed upon with the Manufacturer. Power supply
connector features dimensions 5.5 / 2.1 mm (outer and inner diameters). Positive terminal
of the source is on the central contact.
1.2.3 LAN interface connector
LAN connector is purposed for connecting to Ethernet switch using a straight cable. Bit rate
10 or 100 and duplex mode are software selectable. Indicators built into the connector
mean the following: left one (green) – connection (Link) and data transmission (Activity),
the right one –yellow) – activation of half-duplex mode.
1.2.4 USB CONSOLE
The console port provides local control of the device.
1.2.5 RESET button
Router reset is provided using this button. Also, using special combination of pressings this
button allows router reset to factory settings.
Figure 9 Radio equipment power supply control.
1.2.6 High-speed demodulator IF input (SCPC RX)
SCPC-RX is one of the two signal inputs to receive signals from the satellite (LNB). This
input is designed to receive continuous (SCPC/MCPC) carriers in DVB-S and DVB-S2 formats
from the satellite. The input, on the router side, can be fed with 13 or 18 V power supply.
Input 24V
TX Out
modulator power on|off
demod lnb power on|off
DC-DC
10 MHz
modulator reference on|off
13V
18V
TDMA RX
tdma reference on|off
Self-recovery Fuse
SCPC RX
demod polarization a|b hor|ver