Owner Manual

3.2. Wheels installation

1) Nut (1 piece)

2) Large washer

3) Hexagonal spring washer

4) Wheel with screw

 2 wheels with brakes should be installed on the gas cylinder

compartment door side

 2 wheels without brakes should be installed on the opposite side

 Place the screw through the hole in the bottom of the device and

secure it with hexagonal washer and large washer with nut from inside

Fig 4 – Wheels installation

3.3. Installation of the glass screens and metal hood

 Carefully remove cardboard and foam foil from the glass screens.

 Remove all contaminations from the glass shields which could burn out on the glass during operation of the FARO

(in particular fingerprints).

 Install glass shields in the corresponding slots on the top of appliance.

 Install the metal hood on the top of the all four glass screens

 Remove the glass shield only in case of damage of the glass.

Fig 5– Installation of the glass in slots and metal hood on glass