Owner Manual

10
Twist-on connection: The most important thing is the black seal. Always check if the seal is present and whether it
hasn’t been damaged during the gas cylinder replacement. Some connections have a knob to fasten them in place
while others require the use of a wrench. Tighten securely (left thread). Using the tool pay attention not to fasten the
connection too tightly as this may damage the seal.
Connection Disconnection
1.
Check if the bottle valve is TURNED OFF turning it
clockwise
2. Remove the protection tip and store it for later use.
1. Turn off the FARO – put it into the OFF position. The
main burner need to be turned off.
3.
Before making the connection check if the black seal
is not damaged.
2.
Turn the bottle valve into the OFF position
(clockwise).
4.
Fit the connecting nut to the cylinder with the use of
a correct wrench or the connecting knob. (left
thread) Do not allow the gas bottle connectors to be
fastened too tightly.
3.
NEVER DO NOT unmount the regulator (or
connecting nut) when the bottle valve is open.
4. TAKE OFF the regulator (or the connecting nut) with
the use of a wrench or a connecting knob.
5.
When the gas flow is required turn the valve of the
bottle counter-clockwise.
 After removing the leak one may open the gas bottle valve again.
WARNING
Check the gas connection for leakage. If anything suggests a leak is present (for instance a characteristic gas smell)
close the gas bottle valve and under no circumstances turn the device off before removing the leak.