Owner Manual

7
• Always use a pressure regulator between the gas bottle and the device.
• Use only approved and certified gas connection linkage.
• Check the flexible hose at least once per month and each time the cylinder is changed. If it shows signs of cracking,
splitting or other deterioration it shall be exchanged for new hose of the same length and of the equivalent quality.
• Do not connect the gas cylinder directly to the appliance without regulator.
• Use only the type of gas and the type of cylinder specified in these instructions.
• The elastic linkage connecting gas to the fireplace is to be led away from sharp edges and hot surfaces. Refrain from
bends and twists of the elastic connection on its full length.
• Remember that the LPG bottle should be stored in a well-ventilated place. LPG gas is heavier than air and its
accumulation near the bottom surface may generate an explosive mixture.
• The gas cylinder needs to be shut if the fireplace is not being used.
• Filling the gas cylinders is to be commissioned to certified gas filling stations.
• Replacement of empty cylinders for full ones is to be conducted only in authorised locations.
3. ASSEMBLY INSTRUCTIONS
3.1. Unboxing and installation
• The contents of the boxes need to be carefully unwrapped from the foam foil.
• Remove the bags with decorative stones from the burner reservoir and place them away from it.
• Carefully pull out the glass shield wrapped in cardboard placed on the inside of the device
• Check the completeness of the elements with the contents list.
• Make sure that the device nor its elements weren’t damaged during the transportation (if they were, notify the supplier).
• Place on a flat, paved surface outside of the building, preferably on the place of final installation. Leave sufficient
space on the side of the appliance where control panel is located (minimum 1 m / 40”).
• The decorative stones are to be scattered evenly around the reservoir to completely cover the burner of the fireplace.
Fig 3 – Decorative stones arranged on burner