Quick guide Easee Equalizer Kit CT
Product overview This kit consists of main components required to install an Easee Equalizer on a charging site with one or multiple circuits. All of the components are tested and guaranteed to work with the Easee Equalizer (E02-EQP). Power meter: Micro Matic / Circutor CVM-E3-mini-ITF-485-IC (part no. 80105) Modbus adapter cable: E02-QPMBC (part no. 80118) Power supply: Meanwell HDR-15-24 (part no. 80104) Current transformer: Wibeee STP-24 split core (CT-clamp) (part no.
Installation instructions Before you start — Please check the safety instructions on the manufacturer’s user guides for all the components of the kit. — WiFi network must be enabled for the Equalizer to work properly. Ensure that there is an active WiFi network and note down the login details. — Install the Easee Installer App on your phone by using the QR code below. 1 Installing Equalizer Kit WARNING! This product shall only be installed, repaired or serviced by an authorised electrician.
TN 3-phase 400 V CT clamps Wiring Connection Modbus adapter 3 Power supply 7 Power supply 2 24 V DC Power meter blue 4 6 brown 5
IT 3-phase 230 V CT clamps Wiring Connection Modbus adapter 3 Power supply 7 Power supply 2 24 V DC Power meter blue 4 6 brown 5
2 Configuring Power meter Configuring the current transformer ratio 1. Identify the current sensor ratio. This is displayed on the current sensor (e.g. 300 A/ 5 A). 2. Press and hold the menu button on the power meter for 3 seconds to enter programming mode. 3. Press the right arrow button twice to access the primary current screen. 4. Press and hold the menu button for 3 seconds to enter edit mode. The digit on the left will start to flash when in edit mode. Use the arrow buttons to move the cursor.
3 Setting up Equalizer To configure the Equalizer on a site with multiple circuits, use the Easee Installer App. Ensure that the Equalizer and the master charger(s) are connected to the same WiFinetwork. Also check that you have NFC enabled on your mobile phone. 1. Go to Ongoing sites or Update existing site and select the site you want to add an Equalizer to. 2. Select Add Equalizer under Site structure. 3. Enter WiFi information (same network to which the chargers are connected). 4.
THIS DOCUMENT CONTAINS INFORMATION THAT IS SUBJECT TO CHANGE WITHOUT NOTICE. Contact details The latest version of this publication can be downloaded at http://easee.support Easee AS Grenseveien 19 4313 Sandnes, Norway Org. nr: 920 292 046 No part of this publication may be reproduced or transmitted in any form or by any means, electronic or mechanical, including, but not limited to, copying, recording, retrieving data, or computer networks without the written permission of Easee AS.
Easee AS Grenseveien 19 4313 Sandnes, Norway .easee.
