User Guide

3
This manual concerns the two versions of
the product: Easee Equalizer (E02-EQP)
and Easee Equalizer HAN (E02-EQ). All
instructions apply to both versions, unless
specified otherwise.
Intended use
This product is intended for optimizing
the power consumption by performing an
automatic load balancing between the
Easee Charging Robot(s) and the building.
It is used to avoid overload and power
interruptions while the electric vehicle (EV) is
being charged.
The product may only be operated with the
approved operating parameters and under
the specified environmental conditions (see
page 5). Uses other than those specified
here are not permitted.
Operating conditions
The product needs to be paired with
a Charging Robot and connected to a
supported meter with the cable provided.
In order for the Equalizer to work, the
smart meter’s communication port in most
Introduction
cases needs to be activated. The Equalizer
supports several smart meters. Find a full
list of compatible meters at easee.support.
For installation and operation purposes,
a smartphone with internet connection is
needed.
Optimal performance
The Equalizer makes it possible to charge
smarter, safer and faster if the installation
is scaled accordingly. To enable its true
potential, the rated value of the chargers
circuit fuse should be as high as possible
compared to the main fuse. Even in 1-phase
setups, we recommend using a 3-phase
cable to future proof the installation.