User Guide

7
stronger signal. If necessary, install a Wi-Fi
extender (Mesh) for portable connection.
How to make sure the Equalizer is displaying
the correct values? Do the following steps:
Via the Easee Installer App, go to Site Overview
→ Site Structure → Equalizer, you can click on the
product card and get the same visual image of
the Equalizer that the customer gets via their
Easee app.
Here you can confirm that the same ampere
values are displayed as on the Eastron meter.
Ampere values can be found on the Eastron
meter by clicking on [U / I] and scrolling to
ampere values (A).
Ampere values screen
LED colours meaning
3
Use the Easee App to set up the WiFi.
4
Contact your utility company to activate the HAN port.
5
Go to http://easee.support.
6
Check your internet connection.
7
After booting, it can take a few minutes before Easee Link
RF
TM
status flashes green.
White, fast flashing – Booting
White, breathing every 10s – Normal
operation
Red / white, switching – No WiFi added
3
Red, flashing – No data from power meter
4
Red, breathing every 10s – Error
5
Purple, breathing every 10s – Offline
operation
6
Touch the Easee logo in the middle to
check power consumption:
Blue, fast flashing – High power
consumption
Blue, slow flashing – Low power
consumption
Count the flashes for percentage –
1 flash (10%), 2 flashes (20%),
up to 10 flashes (100%)
Hold the Easee logo for 3 seconds to check
connectivity. You will see 2 flashes:
1st flash – Easee Link RF status
7
2nd flash – WiFi status
Green – Connected
Red – Not connected
3
''