User Manual

42
MV-2505-02--2022
.
eeese-air-care.com © All rights reserved eeese air care aps
UK
L4
Air inlet temperature is
too low >0ºC
Slowly ash L4
Compressor stop working,
fan works at low fan speed.
10mins later, if the
temperature increase to
above 2 machine will
work normally.
9. Trouble Shooting
Check the following before contacting technical support .
PROBLEM POSSIBLE CAUSE SOLUTION
The device does
not work
The power is not connected
Insert the plug into the wall
outlet
The water tank is full Empty the tank
The tank has not been replaced
correctly
Replace the tank
Water removal ca-
pacity is too low
Runtime is too short Be patient and wait
Ambient temperature or humidi-
ty is too low
It is normal that the device
does not dehumidify in these
conditions
The device works,
but reduces the
relative humidity
insuiciently
The room is too big
We recommend using a dehu-
midier with a greater capacity
There is too much ventilation
Reduce ventilation (e.g. close
windows and shut doors)
The air lter is clogged Clean the air lter
Set humidity is higher than the
ambient humidity
Set the humidity lower than
ambient humidity
Dehumidier is
blowing out warm
air
The dried air is passed over
heating coils before it is blown
into the room as part of the
dehumidifying process
This is normal, a dehumidier is
not an air cooler
The display is not
showing the hu-
midity set point
The display shows the room rel-
ative humidity not the set point
Press the humidity control
button once to see the target
relative humidity
Water on oor
There is residual water in tank,
and the device is lurched too
much by moving
Be careful when moving the
tank
The dehumidier is
noisy
The air lter is blocked or the
device is on an uneven surface
Clean the lter or put the de-
vice on a at surface