User Manual

MV-2505-02--2022
.
eeese-air-care.com © Alla rättigheter reserverade eeese air care aps
27
SV
3
When used regularly , the filter may become clogged with dust and particles. Therefore the filter should
be cleaned at least every two weeks. Follow these steps:
1. Switch the device off and remove the plug from the socket before
cleaning.
2. Clean the housing with soft, dry cloth. If the device is extremely dirty,
use a mild cleaning agent. Wipe the dehumidifier with a slightly damp
cloth. Never spray the device with water.
3. Remove the filter, clean the filter with a vacuum cleaner or soapy
water no hotter than 40℃.
4. Rinse and dry the filter completely before installing back to the
device.
8
Cleaning
1
Product Instructions
Safety Instructions
The dehumidifier is used to remove excessive moisture from the air. The resulting reduction in relative
humidity protects buildings and their contents from the adverse effects of excess humidity.
The environmentally friendly R290 is used as the refrigerant. R290 has no damaging influence on the
ozone layer (ODP), a negligible greenhouse effect (GWP) and is available worldwide. Because of its
efficient energy properties, R290 is highly suitable as a coolant for this application. Special precautions
must be taken into consideration due to the coolant's high flammability.
This appliance can be used by children aged from 8 years and above and persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge if they have been given
supervision or instruction concerning use of the appliance in a safe way and understand the hazards
involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made
by children without supervision.
The unit is designed only for use with R-290(propane) gas as the designated refrigerant.
THE REFRIGERANT LOOP IS SEALED. ONLY A QUALIFIED TECHNICIAN SHOULD ATTEMPT
TO SERVICE!
Do not discharge the refrigerant into the atmosphere.
R-290 (propane) is flammable and heavier than air.
It collects first in low areas but can be circulated by the fans.
If propane gas is present or even suspected, do not allow untrained personnel to attempt to find the
cause.
The propane gas used in the unit has no odor.
The lack of smell does not indicate a lack of escaped gas.
If a leak is detected, immediately evacuate all persons from the store, ventilate the room and contact
the local fire department to advise them that a propane leak has occurred.
Do not let any persons back into the store until the qualified service technician has arrived and that
technician advises that it is safe to return to the store.
No open flames, cigarettes or other possible sources of ignition should be used inside or in the vicinity
of the units.
Component parts are designed for propane and non-incentive and non-sparking. Component parts
shall only be replaced with identical repair parts.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
The appliance shall be disconnected from its power source during maintenance.
Ensure the unit is far away from fire, inflammable, or explosive objects.
Do not use means to accelerate the defrosting process or to clean, other than those recommended
by the manufacture.
Ta bort luftintagsgallret, rengör ltret med en dammsugare
eller tvålvatten, vattnet får inte vara varmare än 40°C.
4
Skölj och torka ltret helt innan du sätter tillbaka det
ienheten.
7. Förvaring
Om avfuktaren inte kommer att användas under en längre tidsperiod ska följande åtgärder
vidtas:
1. Dra ut kontakten ur uttaget och töm tanken, se till att tanken är tömd och att
avfuktaren är helt torr. Det kan ta ett par dagar.
2. Rengör luftltret.
3. Kontrollera att avfuktaren är i perfekt skick för att säkerställa en säker användning av
den efter en längre tids förvaring.
4. Packa enheten med lämplig förpackning.
5. Förvara avfuktaren på en dammfri plats och där den inte utsätts för direkt solljus.
Helst täckt med ett plastark.
8. Felkoder på displayen
Kontakta din lokala återförsäljare om någon av felkoderna nedan visas.
Kod Fel Visa Vad händer
E1 Temperatursensor
Blinkar var 30:e
sekund
Enheten avfuktar fortfarande
men körs endast i avfrostnings-
läge.
E2
Fel på luftfuktighets-
sensorn
Blinkar var 30:e
sekund
Enheten avfuktar fortfarande
men körs endast i kontinuerligt
avfuktningsläge.
L3
Luftintagstemperatu-
ren är för hög >42 ºC
Blinka långsamt L3
Kompressorn slutar fungera,
äkten arbetar med låg äktha-
stighet. 10 minuter senare - om
temperaturen sjunker till under
40 ºC - kommer maskinen att
fungera normalt.