Owner's Manual
16 Specications are subject to change without notice
Supernova MKVI DSP Manual 9
AMPLIFIER PLATE OVERVIEW
15
14
16
13 12
10
(10) DSP PAIRING
Used this button to pair a mobile device
via Bluetooth and to factory reset
iWoofer™. To lock password press/
hold for 3 seconds.
(11) VOLUME CONTROL
These remote buttons and knob allow
the user to control the volume of the
subwoofer. Always start at the lowest
setting and slowly increase the volume
until the desired subwoofer level is
reached. Use the MUTE button on the
remote to mute or un-mute the sub-
woofer.
(12) IR INPUT
Used to control the amplier using the
included remote control. Simply plug
the remote eye in the IR INPUT.
(13) POWER & SIGNAL LED
This LED indicator reects the main
power status of the amplier as well as
the state of the amplier (whether the
AUTO Sensing is on/off and whether
signal is being fed to the amplier). Note
that this LED will only illuminate when
the main power switch is in the ON po-
sition.
(14) 110V/220V AV SELECTOR
The MKVI DSP can operate in a 110-120V
or 220-240V environment. Simply slide
the selector switch to the required
power setting and replace the fuse to
the proper rating prior to connecting to
any power source.
(15) POWER SWITCH
Used to turn the MKVI DSP amplier
power on or off. Set this switch to the
ON position in order to use the AUTO
ON function as described in section (5).
(16) AC POWER INPUT WITH
BUILT-IN FUSE
The AC line connector is fused to pro-
tect the subwoofer from unwanted
power surges. Be sure to use the proper
fuse rating when replacing the fuse. To
access the fuse compartment, simply
unplug the subwoofer from any power
source and place a at-head screw
driver in the small notch and pry it open
as illustrated below.
110-120V~60Hz:ø5x20mm, T6.3AL/250V
220-240V~50Hz:ø5x20mm, T3.15AL/250V
ROOM TUNING WITH iWoofer™
Main Menu Cont’d
Xover Control
The XOver or Crossover control allows
the user to control both the Low Pass
and High Pass lters by double tapping
the curve, or pressing and holding it for
more than 1 second. The curve can then
be slid left to right to control the fre-
quency from 20Hz up to 500Hz. The
curve can also be slid up and down to
control the order of the lter up to an
8th order or 48 db/oct lter.
To add a fully Parametric Equalizer
(PEQ), select the “+” icon. Up to 25
bands can be added, to remove a band
select the trash icon. Double tap or
press and hold a band for more than one
second to select it. Once selected, slide
the band left or right to change the fre-
quency and up and down to control the
gain. You can also use two ngers in a
zoom in or zoom out fashion to change
the Q factor, or PEQ bandwidth.