Owner's Manual

12 Specications are subject to change without notice
Supernova MKVI DSP Manual 13
For a more realistic sound stage and
greater theater experience, we suggest
having two (2) subwoofers and running
them in stereo.
Using a “Y” RCA cable, connect the SUB
PRE OUT 1 of the receiver to the LOW
LEVEL INPUT of the left side Supernova
MKVI DSP amplier.
Using another “Y” RCA cable, connect
the SUB PRE OUT 1 of the receiver to
the LOW LEVEL INPUT of the right side
Supernova MKVI DSP amplier.
In case the subwoofers become of out
of phase with the main front speakers,
ip the phase switches to correct the
problem. Note that maximum bass is
only achieved when the subwoofer is in
phase with the rest of the speakers in
your audio system.
SUR. BACK
CENTER
FRONT
SURROUND
PRE OUT (SINGLE)
SUB
BACK OF
TYPICAL A/V
RECEIVER OR
PROCESSOR
If the distance between the MKVI DSP
subwoofer and the audio source is ex-
cessive and susceptible to noise inter-
ference, use the fully balanced XLR
input if your A/V receiver or processor
supports an XLR output. This is a true
balanced input and both conductors are
isolated relative to ground.
XLR OUTPUTS
FROM SOURCE
+ / hot in-phase
- / cold / out-of-phase
/ shield / drain wire
1
2
3
OCNG
1
3
2
XLR PINOUT DIAGRAM
FRONT VIEW OF XLR CONNECTORS
XLR PINOUT DIAGRAM
OF MKVI DSP 15 AMPLIFIER
LOW LEVEL SETUP - DUAL SUBS BALANCED XLR SETUP - SINGLE SUB