Use and Care Manual

ASSEMBLING

1. Remove all parts from package.

Check all the parts against the list in the manual. If any parts are damaged or missing do not use

the garden shredder until the part is repaired or replaced. Call our customer service help line at

1-800-313-5111 for assistance.

2. Position the left leg and right leg on the machine and fix with flange bolts, using hex key end of the

Combo Socket/Hex key wrench provided. (See Fig. 1a, 1b).

3. Insert axle into axle tube (cover). Place washers over each end of axle and slide axle through the

holes in the legs. Add washer and spacer to either end, then install the wheels. Add one more wash-

er and install hex nut over the threaded ends of the axle. Tighten hex nuts by rotating socket

wrenches (provided) in opposite directions (See Fig. 2a, 2b)

4. Press the wheel covers into the wheels to cover the ends of the axle. You may use a hammer to

seat them securely over the axles. There may be some clearance between the wheel and the wheel

cover. It is not necessary to press it to the bottom (See Fig. 3a, 3b)

Fig. 1b

Fig. 2b

Fig. 3a Fig. 3b

Fig. 2a

Fig. 1a