Installation Guide

INSTALLATION INSTRUCTIONS
Select a suitable posion to mount your hose reel.
The hose reel must be mounted on a sturdy surface
(brick wall, solid wood post, etc). The Hose Reel
should be mounted at approximately waist height.
Align the back of the hose reel with the wall bracket.
Insert the securing pin through the holes in the
bracket.
Aach the 15 foot inlet hose to your tap with the
male to female adapter (part E). Test to ensure the
hose reel rotates freely 180 degrees with the inlet
hose connected
YOUR HOSE REEL IS NOW FULLY ASSEMBLED
STEP 1
Using the bracket as a template, mark the locaon of
the screws. Ensure the bracket is level. Drill four 2”
deep holes in the marked locaon. Insert the wall
plugs.
Re-align the bracket to the four holes. Ensure the
bracket is level. Fasten the screws into the wall plugs
unl the bracket is secured.
STEP 2
STEP 3
Aach the hose gun to the hose end using the male
to male (part D) quick connect adapter
STEP 4
STEP 5
STEP 6