Manual

PAGE 3
1/4 - 20 Locknut
1/4 - 20 x 1-1/2” Bolt
1/4 - 20 x 1-1/2” Bolt
1/4 - 20
Locknut
Gauge & Linkage Assembly
Control Lever
& Gauge
12. CALIBRATION: this stEp EnsurEs thAt your sprEAdEr is propErly
AdjustEd to givE you A corrEct stArting point to Apply mAtEriAls At thE corrEct
sEtting. Pull the Control Lever back to #30 on the Gauge, then push the shut-off plate
forward until the shut-off and the drop holes are fully open. Now tighten the Hex Nut
on the ½” Carriage Bolt on the Linkage Assembly. Check to conrm calibration by
closing the Control Lever, then reopening to #30 and conrm that the drop holes are
fully open.
13. Insert agitator to pinion shaft on inside of hopper.
NOTE: Position of at side of the agitator as shown at the
right.
10. Attach Linkage Pivot with 1/4-20 x 1½” Hex Bolt, Flat
Washer, Spacer and Locknut as shown below. Next install
Control Rod into the Shut-Off Plate as shown at the right.
TIP: Make sure that the Control Rod is above the Lower
Handles.
60088
Gauge & Linkage
12147
Spacer
32103
1/4-20 Locknut
31100
1/4-20 X 1-1/2" Bolt
and 34108 Washer
41256
Control
Rod
36500
1/2” Carriage
Bolt
34100
Washer
32108
Hex Nut
60088
Linkage
12317
Shut-off
Plate
41256
Control
Rod
25304
Handle Shaft
12317
Shut-Off
Plate
60088
Linkage
32108
Hex Nut
34100
Washer
41256
Control
Rod
11. Using ½” Carriage Bolt, install through the Control Rod, Linkage and install the Flat
Washer and secure with Hex Nut to a loose t to allow for CALIBRATION below. See
above right and below for details.