EQD Afterneath

3
<<< Installation >>>
1. Power off and unplug your Eurorack case or power supply, and locate 16hp of empty space
within your system.
2. Connect the 10-pin end of the included ribbon cable to the power pin header on the back of
your Afterneath module so the red stripe on the cable is oriented towards the words “Red
Stripe” that are printed on the circuit board. Connect the 16-pin end of the ribbon cable to the
bus board of your Eurorack case according to the specications of your case or bus board
manufacturer. Be certain that you have oriented your cable properly or you may cause damage
to your module or system.
3. Afx the module to your case with mounting screws that are compatible with your case, and
cover any remaining open space with blank panels.
<<< Tech Specs >>>
• Width: 16HP / Max Depth: 31.75 mm
• Current Draw: 95 mA from the +12v rail, 0 mA from both the -12v and +5v rails
• Standard 10-pin Eurorack power connector with a marking to notate the negative pins
• Skiff friendly – protrudes less than 1.25 inches (31.75 mm) behind the panel with the power
header installed
• Audio input capable of handling input signals ranging from instrument-level to modular-level,
depending on the setting of the Input knob
We recommend the use of a high quality, low noise power supply.
<<< Warranty >>>
We will x any of our devices for as long as we are in business. There is never a charge
unless the circuit board needs to be replaced due to user damage such as a failed non-factory
repair, incorrect power supply, reverse-voltage, modication, water damage, etc. Please email
[e-mail] for any questions or to initiate a warranty claim.