WALK BEHIND EDGER OPERATORS MANUAL WE43 (manual start) wE43e (electric start) GetEarthquake.com OMWE43E Rev. 12/16/09 © 2009 Ardisam, Inc. All Rights Reserved.
OPERATOR INSTRUCTIONS and parts WE43E & WE43 Edger Page 800-345-6007 GetEarthquake.
OPERATOR INSTRUCTIONS and parts WE43E & WE43 Edger Thank You and congratulations! on your purchase of a new Earthquake® WALK BEHIND Edger from Ardisam, Inc. We have worked to ensure that your Earthquake Walk Behind Edger will be one of the most trouble-free and satisfying pieces of equipment you have ever owned. With proper care, your edger will provide many years of service. Please take the time to read this manual carefully to learn how to correctly operate and maintain your equipment.
OPERATOR INSTRUCTIONS and parts WE43E & WE43 Edger REGISTRATION Record your model number and serial number in the space provided for easy reference. Fill out and mail the registration card located in your parts packet. Warranty is valid only if the completed registration card is received by Ardisam, Inc., within 30 days of purchase.
OPERATOR INSTRUCTIONS and parts WE43E & WE43 Edger WARNINGS AND CAUTIONS warning warning INDICATES A HAZARD WHICH, IF NOT AVOIDED, COULD RESULT IN DEATH OR SERIOUS INJURY AND/OR PROPERTY DAMAGE. The blade of the edger should not rotate when the engine is idling. If it does rotate when engine is idling, refer to troubleshooting guide for remedy. Read this entire manual before you assemble and operate your new edger. Be thoroughly familiar with the controls and the proper use of the equipment.
OPERATOR INSTRUCTIONS and parts WE43E & WE43 Edger warning caution Hot gases are a normal by-product of a functioning catalytic converter. Follow all safety instructions to prevent burns and fires. INDICATES A HAZARD WHICH, IF NOT AVOIDED, MIGHT RESULT IN MINOR OR MODERATE INJURY AND PROPERTY DAMAGE. Never store engine with fuel in the tank inside an enclosed area or building. Fuel and fuel vapors are highly flammable.
OPERATOR INSTRUCTIONS and parts WE43E & WE43 Edger general SAFETY rules SPECIAL MESSAGES Your manual contains special messages to bring attention to potential safety concerns, machine damage as well as helpful operating and servicing information. Please read all the information carefully to avoid injury and machine damage. NOTE: General information is given throughout the manual that may help the operator in the operation or service of the machine.
OPERATOR INSTRUCTIONS and parts WE43E & WE43 Edger • Always have an adult fill the fuel tank. • Never allow an adult or anyone under the influence of drugs or alcohol to fill fuel tank. • Never allow children to fill the fuel tank. • The clutch will transfer maximum power after about two hours of normal operation. During this break-in period clutch slippage may occur. The clutch should be kept free of oil or other moisture for efficient operation.
OPERATOR INSTRUCTIONS and parts WE43E & WE43 Edger SAFETY DECALs This edger has been designed and manufactured to provide you with the safety and reliability you would expect from an industry leader in outdoor power equipment manufacturing. Reading this manual and the safety instructions it contains will provide you with the necessary basic knowledge to operated this equipment safely and effectively.
OPERATOR INSTRUCTIONS and parts WE43E & WE43 Edger UNPACKING AND ASSEMBLY FOR MODEL WE43E ELECTRIC START CHARGING THE BATTERY UNPACK EDGER 1. Set aside the operators manual and parts bag. Carefully lift the edger out of the box, remove any packing material and cut any ties holding the handlebar pieces to the edger assembly. ASSEMBLY 1. Stand the edger assembly upright with wheels on a level surface. DO NOT place the edger on a high surface where it can fall and cause property damage or personal injury.
OPERATOR INSTRUCTIONS and parts WE43E & WE43 Edger OPERATING YOUR EDGER IMPORTANT Preparing Engine for Starting tHIS ENGINE USES A GAS/OIL MIXTURE. DO NOT RUN ON STRAIGHT GAS ONLY, ENGINE DAMAGE WILL RESULT. Gas and Oil Quality To operate the engine, we recommend using “VIPER” brand 2-cycle oil (PN 300400) to ensure that the engine operates correctly throughout the life of the engine. Use unleaded regular gas only. NOTE: VIPER oil can be purchased from our web site at www.GetEarthquake.com.
OPERATOR INSTRUCTIONS and parts WE43E & WE43 Edger Cold engine Start: Starting engine for first time or after engine has cooled off or after running out of fuel. 1. Move choke lever to RUN position. NOTE: Choke must be in the RUN position when pushing or using the primer bulb. 2. Prime unit until primer hose is filled with gas. NOTE: When using the primer bulb, allow the bulb to return completely to its original position between pushes. 3. Move choke lever to CHOKE position.
OPERATOR INSTRUCTIONS and parts WE43E & WE43 Edger MAINTENANCE ENGINE MAINTENANCE caution Practice safety at all times. Engine must be turned off and allowed to cool, and spark plug wire must be disconnected before attempting any maintenance or repair. STEPS FOR WORKING ON equipment 1. Turn off engine switch. 2. Disconnect the spark plug wire from the spark plug. 3. Securely place the disconnected spark plug wire away from the spark plug and any metal parts.
OPERATOR INSTRUCTIONS and parts WE43E & WE43 Edger LONG TERM STORAGE IMPORTANT If your edger will not be used for more than one month, prepare it for long term storage. Never twist air filters when cleaning. Always press. Steps for Long Term Storage Steps for Cleaning Air Filter 1. Wash in warm water with liquid detergent and water until dirt and debris are removed. Press filter when washing, do not twist. 2. Rinse in warm water until soap and dirt are removed. 3.
OPERATOR INSTRUCTIONS and parts WE43E & WE43 Edger TROUBLESHOOTING Problem Possible cause Remedy/Action Engine will not start 1. Power switch off 1. Flip switch to on position 2. Spark plug wire disconnected 2. Connect spark plug wire to spark plug 3. Out of fuel 3. Refuel 4. Spark plug wet, faulty or improperly gapped 4. Clean, replace or gap spark plug 5. Throttle control not held open 5. Hold throttle control open when pulling recoil handle 6.
OPERATOR INSTRUCTIONS and parts WE43E & WE43 Edger WE43E HANDLEBAR PARTS 3 (2) 24 21 16 17 18 4 (2) 5 (2) 6 (2) 22 20 23 14 6 (2) 26 (2) 10 19 4 (2) 5 (2) 8 1 (2) 1 kEY Part # Description 1 300471 BOLT, M5 X 12MM 3 2 46140 KEY SWITCH 1 3 4639 Handle Grip 2 4 4640 Nut, T-Handle 4 5 4641 Washer 4 6 4642 Bolt, Handle Clamp 4 7 4656 BATTERY BOX MC43E 1 8 4657 COVER, BATTERY BOX 1 9 4659 VOLTAGE RECTIFIER 1 2 13 11 12 7 9 Qty.
OPERATOR INSTRUCTIONS and parts WE43E & WE43 Edger WE43E MAIN PARTS KEY 2 9 5 14 15 13 12 7 3 8 20 6 Part # Description 1 4634 WHEEL Qty. 3 2 4656 BATTERY BOX 1 3 4657 COVER, BATTERY BOX 1 4 4687 BOLT M10 X 1.
OPERATOR INSTRUCTIONS and parts WE43E & WE43 Edger WE43 HANDLEBAR PARTS 1 (2) 14 11 6 7 8 2 (2) 3 (2) 4 (2) 12 10 13 5 4 (2) 9 2 (2) 3 (2) kEY Part # Description Qty. KEY Part # Description 1 4639 Handle Grip 2 9 400008 HANDLEBAR LOWER 1 2 4640 Nut, T-Handle 4 10 4800 THROTTLE HOUSING 1 3 4641 Washer 4 11 4803 CLEVIS PIN, .188 DIA. GROOVED 1 4 4642 Bolt, Handle Clamp 4 12 4804 E- CLIP, RETAINING RING FOR .
OPERATOR INSTRUCTIONS and parts WE43E & WE43 Edger WE43 MAIN PARTS KEY 6 11 12 10 4 9 Part # Description 1 4634 WHEEL Qty. 3 2 4687 BOLT M10 X 1.
OPERATOR INSTRUCTIONS and parts WE43E & WE43 Edger ENGINE PARTS 41 41 12 13 11 10 51 48 27 49 52 46 38 37 47 48 49 27 45 25 26 53 33 34 32 50 35 43 36 42 22 16 17 18 55 24 42 23 20 40 19 39 16 40 14 1 3 5 6 7 8 9 41 56 57 54 15 21 41 44 41 2 3 4 6 7 8 41 Page 20 800-345-6007 GetEarthquake.
OPERATOR INSTRUCTIONS and parts WE43E & WE43 Edger ENGINE PARTS LIST KEY PART # DESCRIPTION QTY.
wE43e & WE43 EDGER Warranty Terms and Conditions Product Warranty: 1-Year Limited Warranty Ardisam, Inc., a manufacturing company, warrants this Earthquake® WALK BEHIND Edger to be free from defects in the material or workmanship for a period of one year from the date of purchase. During the one year warranty of this product, Ardisam will furnish 100% parts and labor to correct any defect caused by faulty material or workmanship.
OPERATOR INSTRUCTIONS and parts WE43E & WE43 Edger Explanation of Emissions Control Warranty Provisions Viper Engines are designed, built and equipped to meet all EPA requirements. It warrants that it is free from defects in material and workmanship that could cause failure to the warranted part; and that it is identical in all material respects to the engine described in the manufacturer's application for certification.
Visit www.ardisam.com and discover more innovations that will benefit you throughout the year. Earthquake, Division of Ardisam, Inc. 1160 Eighth Ave; P.O. Box 666 Cumberland, Wisconsin 54829 800-345-6007 · Fax (715) 822-4180 E-mail: info@ardisam.com GetEarthquake.
