43 Ope _nuai IBE43 2/8/05 ,_c_ Copyright 2005 Ardisam, Inc. All Rights Reserved. Printed in USA.
iNTRODUCTiON, REGiSTRATiON ANDWAR NTY THANK YOU.,. for purchasing an Earthquake@ Power Earth Auger from Ardisam, Inc. We have worked to ensure that it meets high FHIout and mall the registration card bcated in your parts packet. Warranty is valid only if your completed registration card is received by Ardisam, Inc., at time of purchase. standards for usability and durability. ½1;thproper care, your auger will provide many years of service.
Accurate assemMy and safe and effective use of the auger is the owner's responsibility, ,, Read and follow aH safety instructions, ,, Carefully follow aHassembUy instructions, Please read this section carefully.
Warning Carbon Monoxide Poisoning AHH engines contain carbon monoxide in their exhaust, Carbon monoxide is a deadiy, coloriess, tasteless, odoriess gas which may be present even if you do not smeli or see any engine exhaust, Leveis of carbon monoxide, which can be deadiy, can be present for days in an enciosed area that has poor ventilation, Any ievei of carbon monoxide, if inhaled, can cause headaches, drowsiness, nausea, dizziness, confusion and eventualiy death, if you experience any of these symptons, s
Burns ond Fires The muffler, muffler guard and other parts of the engine become extremeUy hot during the operation of the engine, These parts remain extremeUy hot after the engine has stopped, Prevention * Avoid injury! A!ways wear hearing operating engine.
Filling Fuet Tank I, Shut-off engine and allow engine to completely cool before refilling the fuel tank, 2, Move to a well ventilated area, outdoors, away from flames and sparks, 3, CAUTION 4, Loosen fuel cap slowly, Place the cap on a clean, dry su dace, 5, Avoid injury! Never mix rue! and oil directly in engine fuel tank. Use only non=meta!, portable fuel containers approved by the Underwriter's Laboratory (U.L) or the American Society for Testing & MateriaJs (ASTM).
OPERATION StertingondStoppiBg Enoine 1, Move engine to a well ventilated area, outdoors, to prevent carbon monoxide poisoning, 2, Move to an area away from flames or sparks, to avoid ignition of vapors if present, 3, Remove aH debris from air charier hobs and fueUcap to ensure proper air flow, 4, Turn switch to the ON position, 5, Priming: 8. Pull recoil until engine fires or runs. NOTE: If engine fails to start after 5-6 pulls, push primer 1 time and putt starter rope again.
MAINTENANCE ANDSTORAGE Cooling To prevent accidental starting:: Avoid injury! Engine must be turned off and cool, and spark plug wire must be removed from spark plug before checking and adjusting engine or equipment. i ,cAuTuoN Avoid injury! Tempera_re OfomUffler and nearby l areas may exceed 150 F (65 C). Avo d these areas.
MAINTENANCE ANDSTORAGE TronsportinO YourEarthAuoer LongTermStoroge 1. Never transport engine inside an enclosed space or vehicUe. FueUor fueUvapors may ignite causing serious injury or death. ,, If your earth auger will not be used for more than one month, prepare it for long term storage. 2. UffueU is present in the fueUtank, transport in an open vehicUe in an upright position. 3. Ufan enclosed vehicUe must be used, remove gas into an approved red gasoline container. DO NOT siphon by mouth. 4.
SERVICE, TROUBLESHOOTING ANDREPAIR ORDERING REPAmR PARTS SERVmCE mNFORMATION Parts can be obtained from the store where your auger was purchased or direct from the factory. To order from the factory, call or write to: mNCASE OF A SERVmCE PROBLEM, DO NOT SEND UNmTBACKTO RETAILER. CONTACT ARDmSAM, mNC. AT 1-800-345-TOO7.WEWELCOMEYOUR CALL. Ardisam, inc.
SERVICE, TROUBLESffOOTIN6 ANDREPAIR CAUTION Practice safety at aH times. Engine must be turned off and allowed to cool, and spark pJug wire must be disconnected before attempting any maintenance or repair. Engine will not start 1. Power switch off 2. Spark plug wire disconnected 1. Flip switch to on position 2. Connect spark plug wire to spark plug Engine runs rough, floods during operation 1. Dirty air cleaner 2. Choke partially engaged 3. Carburetor out of adjustment 1.
v_ O 9 co 4_ o3 o o *-4 300471 !021\ 300477 8 (2) 300486 30043' \\ \ _300489 88 300458 7 5 '300456(2) 9O 300493 300476 BM6A -300482 300483 300439 _--300455
E43ENGINE PARTS UST POWERHEAD PARTS Part # 300470 Description 1 Fuel Line Hose & Filter 1 Muffler Cover, Metal 1 300471 Bolt, M5 x 12mm 3 300401 300412 300429 Fuel Tank Cap Clutch Spring Recoil Plate 300430 300435 300437 Recoil Assembly Air Filter Fuel Tank 1 1 1 1 1 300472 300474 300475 300476 300477 Ignition Coit Catylatic Converter Muffler Gasket Intake Gasket Heat Disk 300438 300439 300442 Bolt w/washer, M5 x 25ram Bolt w/washer, M5 x 18mm Clutch Rotor Shoe 1 6 300478 300479 Intak
[4a @R1"$LIST 1022 _1023 _--_ j4809 ....... 300496 / / ÷J // • - 300414 300409 8922 9814MM 200131 ___I_/J433, 2104 SM 8923 )24 _214 8915 1423, WF516, (2 of each) 60G56 8980 )24 _EA2E EA4K EA8E 8923 1-800-345-6007 EA3K EA6E EAIOF .......
[43 PARTS LtST POWERHEAD Part # 1022 1023 1024 F 48OO 48O2 48O3 4804 48O8 48O7 48O9 4810 481 ! 8904WC 8912 8913 8915 8919 8922 8923 8924 8929 8931F 8939 9214 9814MM 200131 300409 300414 300496 E43CC PARTS EARTH Description Adapter Ring (engine to handlebar Bolt, M6x 1 x !6mm Q_3& 1 plate) AUGER PARTS Part # Description 60G56 ;423 Nut-Hex 2-way reversible k)ckmlt, 5/16- I S Bo_t-HHCS, 5/!6-18 x 2", Grade 5 1433 (auger shock sprh_g) Bolt-HHCS, 3/8- !6 x _- 1/2" (auger to powerhead) 4 (ring to
Ardisam, inc. t690 EmmStreet, Cumberland, Wisconsin 54829 Phone (7t 5)822=2415 • Fax (7t 5)822=4180 t °800°345°8007 Email info@ardisam°com www°ardisam.
