Owner manual
OPERATOR INSTRUCTIONS AND PARTS
CRT Models 5055C & 6065VEC
Page 16
GetEarthquake.com
800-345-6007
ENGINE MAINTENANCE
Refer to the engine manual included in your parts packet for
information on engine maintenance. Your engine manual provides
detailed information and a maintenance schedule for performing the
1. Check oil level before each use or after every 8 hours of operation.
4. Check spark plug yearly or every 100 hours of operation.
5. Service air cleaner.
7. Check engine and equipment often for loose nuts and bolts, keep
these items tightened.
CHECK OR FILL ENGINE CRANKCASE
1. Add oil according to engine manual. Do not overll. Use a
clean, high quality detergent oil. Use no special additives with
recommended oils. Do not mix oil with gasoline. Oil level must
2. Always check oil level before starting engine. Refer to engine
manual for capacity and type of oil to use.
CHECK TILLER TRANSMISSION GREASE
1. Move tiller to level ground.
2. Remove grease level dipstick located between the handlebar
mounts on the engine mount. Correct grease level is indicated
between the high and low levels on the dipstick.
4. Note that the front wheel transmission and rear tine transmission
are one common reservoir. When you add to the front transmission,
and equalize in both front and rear. The dipstick will read correctly
on level ground for both gear units.
(Use Mystik 00, or equivalent, transmission grease.)
CHECK TIRE PRESSURE
Recommended tire pressure is 20 PSI. If tires do not have equal
pressure, tiller will pull to one side.
IMPORTANT
ENGINE IS SHIPPED FROM FACTORY WITHOUT
OIL. YOU MUST ADD ENGINE OIL BEFORE
STARTING ENGINE.
gear case
dipstick
transmission
cover plate
IMPORTANT
TILLER TRANSMISSION IS SHIPPED FROM
FACTORY WITH THE PROPER AMOUNT OF LIQUID
GREASE.
WHEN REPLACING GREASE, THE TILLER
TRANSMISSION HOLDS 18-22 OUNCES. DO NOT
OVERFILL.