Owner manual

OPERATOR INSTRUCTIONS AND PARTS
CRT Models 5055C & 6065VEC
Page 15
GetEarthquake.com
800-345-6007
BELT REPLACEMENT PART #’S:
727A (forward)
730 (reverse)
CHANGE FORWARD/REVERSE BELT
1. Turn off engine. Engine must be cool.
2. Remove spark plug wire and secure from spark plug.
3. Remove belt guard.
  
- Gently pull the engine recoil rope to rotate the pulley.
- With the pulley turning, force the forward belt out of the
V-groove.
- Slide the belt free of the engine pulley.
- Pull the forward belt down and out of the way.
  
- Gently pull the engine recoil rope to rotate the pulley.
- With the pulley turning, force the reverse belt out of the
V-groove.
- Slide the belt free of engine pulleys and reverse belt
guides.
- Pull belt down and away from transmission pulley.
  
NOTE: V side of belt should be up, away from pulley.
- Thread belt up from bottom.
- Place belt around transmission pulley in groove.
- Place belt under reverse belt guides.
- Gently pull engine recoil rope while forcing the belt over the
edge of the engine pulley into the V-groove.
  
- Place forward belt in transmission pulley groove.
- Gently pull the engine recoil rope to rotate the pulley while
forcing the forward belt into the V-groove.
4. Replace belt guard.
5. Attach spark plug wire.

V side up
TRANSMISSION
PULLEY

ENGINE PULLEY
DO NOT OPERATE TILLER BEFORE READING
THE ENGINE MANUAL PROVIDED IN THE PARTS
PACKET.
CAUTION
!
TEMPERATURE OF MUFFLER AND NEAR BY AREAS
MAY EXCEED 150° F. AVOID THESE AREAS.
WARNING
!
IMPORTANT
ENGINE CAN OVERHEAT AND BECOME DAMAGED
IF DEBRIS BLOCKS THE COOLING SYSTEM OR
ROTATING SCREEN.
NEVER RUN ENGINE WITHOUT COMPLETE AIR
CLEANER INSTALLED ON ENGINE.