Owner manual

OPERATOR INSTRUCTIONS AND PARTS
CRT Models 5055C & 6065VEC
Page 13
GetEarthquake.com
800-345-6007
TILLING TIPS
The key to successful tilling is to begin with a shallow cut on the rst
pass, and then work an inch or two deeper on each successive pass.
 
 
soil, set the detent pin in the highest hole of the drag stake (follow
instructions under Tilling section). This will allow for shallow tilling.
With the drag stake in this position, make several light passes
over the area to be tilled. Reset for deeper depths with successive
passes.
 
the detent pin in a higher hole. This will allow for shallower tilling.

  
tines, reverse the tiller to unwind vegetation.
Immediately release the drive control levers if the tines jam or you
strike a foreign object. With drive control levers in neutral position,
push throttle control to stop position to stop the engine. Disengage
the spark plug wire. When tines have stopped, remove foreign objects
and check for damage.
CULTIVATING TIPS

 
 
holes. This will allow for shallow cultivation necessary to turn over
weeds, and break up and aerate the soil.
EXTREME CAUTION MUST BE TAKEN IN SELECT-
ING TILLING DEPTH. IF YOU ATTEMPT TO TILL
TOO DEEPLY FOR SOIL CONDITIONS, THAT IS,
WITH THE DRAG STAKE IN TOO HIGH A POSITION,
LOSS OF CONTROL COULD RESULT.
IF REMOVING MATERIAL FROM THE TINES BY
HAND, STOP ENGINE AND REMOVE SPARK PLUG
WIRE FIRST.
WARNING
!