User Manual

DJ-Quake Sub v2
Left Array Right Array
CONNECTING DJ-ARRAY GEN2 SPEAKERS
The DJ-Array GEN2 speakers are equipped with 1/4″
TRS input connectors at the bottom portion of the
mounting bracket. With the supplied TRS cables,
gently push one end of the TRS cable plug into the
input as shown below and push the other end into
your amplier or powered subwoofer. The DJ-
Quake Sub v2 is a great choice to pair with these
array speakers as it features multiple inputs and
outputs as well as an active 12 inch subwoofer to
create the ultimate and portable DJ system.
Using the supplied 1/4″ TRS cables, connect left
and right DJ-Array GEN2 speaker systems to the
left and right array inputs located on the back of
the DJ-Quake Sub v2 or any other amplier that
supports 1/4″ TRS inputs. You do not need to run
any other speaker cables for these array speakers
due to the convenient internal wiring inside the
mounting bracket.
Earthquake strongly recommends using the HUM
Kleaner active line converter and pre-amplier
when your audio system is susceptible to noise at
the source or when you need to push an audio
signal through long wire runs. Please refer to the
manual before setting up and using this product.
Earthquake Sound Corp. | [phone] | www.earthquakesound.com8 DJ-Array GEN2 Manual
HUM Kleaner