Product Manual

MANUAL BACK TILT
Tilt Top Tables
Every Ergo Lift with manual tilt functionality is equipped with a newly designed locking tilt mechanism
which allows you to tilt the back section of the table in increment levels to accommodate your clients.
Each increment increases the back tilt by 10º. The following steps will guide you through adjusting the
back tilt to the desired level, and then returning it to a at position, or other desired level.
Step 1
To tilt the back section upward
from its at position, carefully
place both hands underneath
the rear edge of the upholstered
top of the tilt section, as pictured
above.
Step 2
Lift the tilt section of the table to
the desired level. The tilt section
will automatically ‘click’ into
position as you lift upward.
Step 3
To return the tilt section to a
at position, release the locking
mechanism by lifting the back
section all the way forward past
90º, until the locking mechanism
releases.
Step 4
Once the locking mechanism is
released, lower the tilt section
until it is at (1), then lift again to
another desired angle (2).
11
Do Not sit, or put unnecessary amounts of pressure on the back
section of the table when it is in tilt position on any level (Diagram
A). This can damage or destroy the tilt mechanism for the back
section of the table and cause harm or bodily injury to persons. The tilt mechanism
of the table is intended solely to be used when a client is properly seated or laying
on top of the table correctly. Damage caused to the table in this manner can void the
warranty.
A