Quick Start Guide

SET VOLUME
UltraLITE features 5 volume settings. Select the desired volume by
slowly clicking the UP or DOWN buttons. An audible tone reflects
volume level. A double tone indicates low or max volume has been
reached.
Battery
All UltraLITE headsets are powered by a Lithium Polymer
battery that will operate 6 hours when fully charged.
IMPORTANT
UltraLITE systems include one
headset labeled “MAIN”.
This MAIN headset must be
turned “ON” to link the corresponding REMOTE headsets.
Charging
1) Batteries are charged via the multi-charger.
2) Insert the batteries making sure the contacts are
properly aligned.
3) RED: Charging; GREEN: Fully Charged.
Installation
1) Press the release button located on the bottom of
the battery compartment.
2) Insert the battery into the compartment (arrow
indicates proper direction) and snap door closed.
Operation
Adjusting for Fit & Performance
1) Adjust the headband slides for size as necessary.
2) Position the microphone capsule at one finger’s width from the
corner of your mouth to ensure superior speech recognition and
noise cancellation.
3) “TALK” identifies front of microphone: always have this indicator facing towards your
mouth.
STARTUP
1) Turn ON the MAIN headset, switch is located below battery
compartment. Flashing blue LED on earcup confirms headset is in
search mode.
2) Turn ON the REMOTE headset(s), press the power button located
above volume controls.. Flashing blue LED on earcup confirms
headset is in search mode.
3) Flashing LEDs change to solid blue to indicate that headsets are
connected.
SHUT DOWN
Power OFF the MAIN headset utilizing switch, then PRESS and HOLD the power button on
the Remote headset(s) for 4-5 seconds to turn off.
(Note: Blue LED on headsets indicates pairing mode. When headset blue LED is NOT
illuminated, this does NOT necessarily indicate that the headset is off. Please check
switch on Main headset to ensure that it is in OFF position. The battery will continue
to drain if left in the headset, and the switch is not turned to OFF position.)
MAIN ON/OFF
REMOTE ON/OFF
AutoMute Function
Microphone
mutes
automatically
when boom is
set to “UP”
position.
Boom
swivels over
the top 270
degrees.
Headset can
be worn on
left or right
ear.
To ensure optimum charge level remove battery from headsets
when system not in use.
(Note: Blue LED on headsets indicates pairing mode. When headset blue LED is NOT
illuminated, this does NOT necessarily indicate that the headset is off. Please check
switch on Main headset to ensure that it is in OFF position. The battery will continue
to drain if left in the headset, and the switch is not turned to OFF position.)
Low Indicator
A repetitive beep (every 20 seconds) indicates low
power – battery should be charged or replaced.
Battery Care
Release Button