Operating Instructions

ManualsBrandsEarlex ManualsDIY power toolsMaxisteam Wallpaper Stripper - 2000W

Steam Wallpaper Stripper

OPERATING INSTRUCTIONS

Thank you for purchasing a Steam Wallpaper Stripper. This is a highly versatile machine for

use all around the home. In order to obtain the best results please read the instructions

before commencing any work.

THE MANUFACTURER WILL ACCEPT NO RESPONSIBILITY FOR THE USE OF THIS PRODUCT IF USED FOR ANY

PURPOSES OTHER THAN THOSE DETAILED HEREIN.

BEFORE USE - PLEASE READ THE MANUAL AND SAFETY INSTRUCTIONS.

Please retain for future use

IF YOU HAVE ANY PROBLEMS WITH YOUR STEAM WALLPAPER STRIPPER OR IF YOU BELIEVE A PART

IS MISSING, DO NOT RETURN TO STORE. PLEASE CONTACT EARLEX LTD ON 01483 454666.

SAFETY CUT-OUT

A safety cut-out is fitted to prevent overheating of the element if the water boils low. If unit stops boiling during use

.this may be the cause. Wait for 2 minutes before removing filler cap then re-fill with water. The cut-out will self-

.reset and steam be produced again within 5-15 minutes.

The cut-out will not protect the element if a part-filled unit is tilted during use in a way which enables part

.of the element to be out of the water for longer than 15-20 seconds. Failure to do so can result in severe

.overheating, complete element failure and void your guarantee.

SS125 SS76 SS77

Summary of content (8 pages)

PAGE 1
Steam wallpaper Stripper SS125 SS76 SS77 OpErATIng InSTrUCTIOnS Thank you for purchasing a Steam wallpaper Stripper. This is a highly versatile machine for use all around the home. In order to obtain the best results please read the instructions before commencing any work. THE MANUFACTURER WILL ACCEPT NO RESPONSIBILITY FOR THE USE OF THIS PRODUCT IF USED FOR ANY PURPOSES OTHER THAN THOSE DETAILED HEREIN. bEFOrE USE - plEASE rEAd ThE mAnUAl And SAFETY InSTrUCTIOnS.
PAGE 2
l l l l l l l l l l l l l l l l l SAFETY rUlES Keep equipment away from children and pets. l Use only standard tap water. Never add detergents or chemicals. Ensure boiler is placed on a flat level surface, and should the boiler become l Extreme care must be taken if the unit is used tilted in use - level again immediately. in bathrooms. Always be aware of danger of Failure to do so can result in severe electrocution from stored water in overheating, complete element failure and baths and sinks.
PAGE 3
CAUTIOn ! Check the state of your plaster before starting work. Steam can loosen weak, porous or poorly bonded plaster - which also loosens readily if cracked, holed or if the steamplate is held in one position for too long after the paper is soaked. Weak plaster can normally be detected by tapping a few areas of wall. A hollow sound indicates that you should proceed only with extreme care - stopping immediately if you hear a cracking sound or plaster starts to break loose.
PAGE 4
OThEr USES FOr ThE STEAmplATE Artex® - Normally Artex® can be removed using the same method as for wallpaper although the steaming time will be longer. CAUTIOn! Some textured finishes may contain asbestos which may be hazardous to health and which are subject to licensing controls operated by the HSE (Health & Safety Executive). vinyl Floor Tiles - Vinyl floor tiles can also be removed if the steamplate is left long enough for the heat to penetrate the adhesive.
PAGE 5
TrOUblEShOOTIng Unit Fails to boil The unit has probably not been left long enough to cool - refer to section on safety cut-out. Check the fuse in the plug is sound and is rated at 13 Amps. l If using an extension lead check that it is rated at a minimum of 10 Amps and fully unwound. l Unit leaks Steam from pressure relief valve The pressure relief valve is a special low pressure valve and cannot be replaced by any other valve.
PAGE 6
NOTES 6
PAGE 7
NOTES 7
PAGE 8
gUArAnTEE This product is guaranteed for a period of 24 months against faulty materials and workmanship. Whilst every possible care is taken by the manufacturer to ensure that our products leave the factory in good working order, the manufacturer cannot under any circumstances accept liability for problems or damage caused by their subsequent use. It is the responsibility of the user to ensure that surfaces to be treated, cleaned or stripped are suitable for steam.