Installation Guide

Spraying direct from the can:

1) The head unit is secured with two container catches. Gently pull outwards on these to dislodge

the catches, and remove the head unit.

2) Unscrew the paint container (Fig.8) and remove the rigid suction tube from the gun (Fig.8) and

then insert the bare end of the 13ft paint tube through the connecting plate and fit it over the

inlet (this is the one with the smaller aperture on underside of the gun) (Fig.9).

Tip: Tube can be softened by running under hot water.

3) Ensuring that it is correctly aligned, screw the adapter onto the gun - pushing as you twist.

4) Fit the the 13ft paint tube to the paint outlet (Fig.10) on the motor unit - using the quick connect

fitting. Give a gentle tug on the paint tube to ensure that it is secure.

5) Set the paint flow adjuster on gun to maximum by scrolling up (Fig.10) and then firmly push/ clip

the gun into the docking station on the motor unit until you hear a ‘click’ (the trigger should be

depressed sitting in the docking station).

6) DO NOT FIT the air hose to motor outlet and gun at this stage yet.

Product - Set up & Assembly

Additional items required before you start: • Drill • Cloth

The Gemini can be set up for two different types of applications,

spraying directly from the can for large projects and also from the

quart cup for small projects.

Fig.8

Fig.9

Fig.10

Switch functionality

Pump

Turbine Paint speed dial Paint flow adjuster

HORIZONTAL

ROUND

VERTICAL

Large Projects

Direct from the paint can (or Gemini bucket)

(water-based coatings only)

DVD

IMPORTANT: Correct cleaning of this sprayer is essential for successful operation on next use.

Please refer to the How to DVD and the cleaning section of your operational manual on how to

properly clean your sprayer.

FF0084-A4-0312_Layout 1 09/03/2012 14:21 Page 7